The Gen5 M.2 M-Key Horizontal Breaker Module is ideal for testing both consumer-grade and enterprise-grade SSDs. This module allows hot-swap, lane configuration, fault injection, and signal driving for Gen5 M.2 M-Key drives.
Gen5 M.2 M-Key 水平断路器模块非常适合测试消费级和企业级 SSD。该模块允许 Gen5 M.2 M-Key 驱动器的热插拔、通道配置、故障注入和信号驱动。

Fitting into a standard M.2 M-Key slot, this module allows advanced, repeatable testing of Gen5 M.2 devices.
该模块安装在标准 M.2 M-Key 插槽中，可对 Gen5 M.2 设备进行高级、可重复的测试。

Controlled from the TestMonkey GUI or any standard scripting language, the module is simple to integrate into your test plan.
该模块通过 TestMonkey GUI 或任何标准脚本语言进行控制，可以轻松集成到您的测试计划中。

The horizontal orientation differs from the Gen4 version due to connector availability and the desire to reduce the vertical height.  The module should fit almost any standard M.2 slot, with the drive sitting horizontally and slightly offset.
由于连接器可用性和降低垂直高度的愿望，水平方向与 Gen4 版本不同。  该模块几乎适合任何标准 M.2 插槽，驱动器水平放置并稍微偏移。

With full control over every active pin, you can perform:
通过完全控制每个活动引脚，您可以执行：

• Full hot-swap control of the attached card
  附加卡的完全热插拔控制
• Individual control of all lanes, sidebands, and power pins
  对所有通道、边带和电源引脚的单独控制
• Glitching of any signals
  任何信号出现故障
• Active driving of selected sideband signals.
  选定边带信号的主动驱动。

This module comes with a 40cm flexible interface cable and requires a separately purchased controller.
该模块配有 40cm 柔性接口电缆，需要单独购买控制器。